Enclosure and mount for LightBurn 8MP (4K) camera module. Mounts with double sided sticky tape. Swivels up/down. 3D printed (PLA)
Available on backorder
3D printed enclosure with universal mount for 8 MegaPixel 4K Lightburn Camera
If you are using Lightburn software for your laser cutter/engraver, it now supports a camera module. This enclosure will let you install this camera module to your laser machine. Enclosure swivels up/down on a simple mount and attaches to top of your laser cover with double-sided tape.
This enclosure fits 90mm x 15mm camera module only. Type of lens is not important, it should work with all of them.
Enclosure is 3D printed from PLA filament.
Camera module NOT INCLUDED
Colors may vary
Enclosure comes with main case, top cover, swivel mount and screws.
First position camera module inside, and secure with three M2x3mm machine screws. Don’t over-tighten.
Position top cover with open end to the same direction as open end of the main case. Check that hole is big enough to pass over your camera lens. Press it down until it latches on and stays securely. If you need to remove top cover, pry it with flat screwdriver using 4 recessed notches on the sides.
Position swivel mount over main case hinge and thread thru M3x30mm machine screw (long one). Secure with M3 cap nut on other end. Loosen nut to turn camera up or down for correct positioning.
Find good spot on your laser cover to attach mount. Clean it with alcohol for better adhesion. Orient camera so that wire coming out the right side, peel protective film from double sided tape on the mount and attach to the cover. Double sided tape is very strong, but can be removed if you have to.
|Dimensions||.1 × .2 × .2 in|